ETL Systems StingRay SRY-RX-L1-466 GPS/GNSS Fiber Optic Receiver 850–2450 MHz

ETL Systems StingRay SRY-RX-L1-466 GPS/GNSS Fiber Optic Receiver 850–2450 MHz

The ETL Systems StingRay SRY-RX-L1-466 is a standalone GPS/GNSS over fiber receiver operating from 850–2450 MHz. Used with a compatible optical transmitter and a tuned GNSS antenna, it converts the incoming optical signal into an RF output for connected GNSS equipment.

The receiver accepts optical wavelengths from 1100–1650 nm, optimized for 1310 nm and 1550 nm. FC/APC and SC/APC connector options support single-mode fiber installations, while 50 Ω SMA or BNC options provide RF output and monitoring connections.

Automatic gain control supports a selectable output level, with a fixed-gain option available after setting the AGC level. A dedicated RF monitor port provides a signal approximately 20 dB below the main output for indication and signal checks.

Its compact, EMC-sealed housing supports tapped-screw and through-hole mounting. Local LEDs indicate power and operating status. Contact Esatcom for applications requiring remote monitoring and control.

Model: SRY-RX-L1-466
Product Type: Standalone GPS/GNSS fiber optic receiver
Frequency Range: 850–2450 MHz
Capacity: One GNSS over fiber receive channel
RF Output: 50 Ω; SMA or BNC connector
RF Monitor Port: 50 Ω SMA or BNC; 20 dB below main output, typ., for indication only
Link Gain: 50 ±3 dB maximum across band and link
Gain Flatness: ±2.0 dB over any 500 MHz; ±0.5 dB over any 36 MHz
Output Return Loss: 18 dB typ.; 12 dB minimum
Gain Control: AGC with selectable output level and fixed-gain option
Optical Wavelength Range: 1100–1650 nm; optimized for 1310 nm and 1550 nm
Optical Input Power: 0 to +4.5 dBm
Optical Connector Options: FC/APC or SC/APC; single-mode fiber
Power Consumption: 4 W maximum at steady state
Operating Temperature: −20°C to +55°C
Mounting: Tapped-screw and through-hole options

Key Features

• Extends GPS/GNSS RF signals over single-mode optical fiber when paired with a compatible transmitter.

• Wide frequency coverage for different GNSS signal bands.

• Dedicated RF monitor port for signal checks.

• Local power and status LED indicators.

• Monitoring of amplifier-stage status and module temperature.

• Compact, EMC-sealed standalone housing.

• Indoor operation; outdoor use only within a compatible ETL ODU enclosure.

Compatible transmitter, tuned GNSS antenna, fiber cables, and other system accessories are sold separately unless included in the quoted configuration. GNSS signal selection depends on the transmitter and antenna configuration. Use APC optical connectors only. Confirm power-supply requirements and available gain-control settings when requesting a quotation.